
Course:	Post-Installed Concrete Anchor Installation Inspector
SAP Course Number:	78TECH401055

Require fiscal data at the course level?

Course can be found when searching
"By Topic" under these categories:

Construction Inspection
Structural Design
Structural Inspection

Class Schedule

No Offerings Are Currently Scheduled

General Information

Summary:	This course is required to become a ACI certified Post-installed Concrete Anchor Inspector. The anticipated audience is Structure Control Engineers and construction inspection staff who will oversee the installation of post installed concrete anchor systems. Participants in this course will receive both written and hands-on training related to the install and inspection of the various types of post installed concrete anchor systems. The participant will receive the course materials in advance and be expected to review the documents prior to the start of the course. To obtain the certification, participant must pass a two part exam. Part1: The forty-five-minute installation examination is closed-book andconsists of approximately 45 multiple-choice questions (minimum score of 74%). Part 2: The two-hour inspection examination is open-book and consists of approximately 90 multiple-choice questions. To pass the installation examination the examinee must attain a minimum score of 60%
Learning Outcomes:	Upon successful completion of this course and passing of the examinations, the participant will be a ACI certified Post-Installed Concrete Anchor Installation Inspector. The Inspector will understand: 1. role on the jobsite. 2. periodic and continuous inspection and under what conditions each is required. 3. correct selection of installation procedures. 4. Proper location of anchors. 5. manufacturer’s instructions and the proper procedures, sequence, and tools to clean the hole. 6. Importance of proper selection and assembly of the injection equipment. 7. Importance of injection of adhesive into holes at various orientations to the proper depth using proper technique and equipment to minimizes air voids. 8. time limits for installation and positioning of anchor element depending on conditions. 9. warning signs of potential deviation from the construction documents and the manufacturer printed
Teaching Method:	Participants in this class will review the learning materials that have been circulated to them as well as a variety of powerpoint presentations and videos.
Target Audience:	Structure Control Engineers and construction inspection staff who will oversee the installation of post installed concrete anchor systems.

Special Materials:	The learning materials for this class will be circulated to attendees in advance of the class.
Final Exam:	Yes

Continuing Education Credits

Miscellaneous	CEHs	Classes After	CEUs	Classes After	PDHs	Classes After

PennDOT:					8.00

Awarding continuing education credits (PDH/CEU/CEH) to a training course or other training event does not imply or guarantee that the training course/event is approved by the Pennsylvania State Registration Board of Professional Engineers, Geologists and Land Surveyors. According to Pennsylvania Act 25, “Credit determination for activities…shall be the responsibility of the licensee. Continuing professional competency obtained by a licensee should maintain, improve or expand skills or knowledge obtained prior to initial licensure, including law and ethics applicable to the profession, or develop new and relevant skills and knowledge.”
For informational purposes only:	1 CEU is equal to 10 hours of instruction
	1 CEH is equal to 1 hour of instruction

Course Contact Information

For technical questions regarding this course, contact the following...
Name:	Jonie L Buggy
Phone:	(717) 787-7541
Email:	jbuggy@pa.gov
For general questions about the Training Calendar (such as those regarding schedules, locations, instructors or registrations), see Contact Information in specific classes.

Created	Last Modified
By Jonie L Buggy/PennDOT On 02/24/20 At 11:46 AM	By Jonie L Buggy/PennDOT On 12/27/21 At 02:04 PM