Independent Study

           
 
 General Information                            Continuing Education Credits                            Contact Us 


Course:
Environmental Special Topics: Management of Fill

Course can be found when searching
"By Topic" under these categories:


Environmental



Description:
This web-based training provides PennDOT's construction and design personnel with information needed to plan for and comply with Pennsylvania Department of Environmental Protection's (PADEP's) Management of Fill Policy. This policy defines clean and regulated fill, establishes procedures to determine fill category and acceptable uses under General Permit for Processing/Beneficial Use of Regulated Fill (WMGR 096SE003), and reporting and record retention requirements. This course will briefly summarize the definitions and policy applications; discuss how to comply with the Environmental Due Diligence (EDD) requirements to determine fill use; and go through the required section of PADEP's August 2010 Certification of Clean Fill form and Form 20 RF- Application for Regulated Fill General Permit. This course follows the procedures in PADEP's revised technical guidance. Discussion on how this Policy affects PennDOT's activities will be included.

Attachment(s):
Mgmt of Fill-Final 111610Speakernotes.pdf

Continuing Education Credits


Miscellaneous
CEHs
Classes
After
 
CEUs
Classes
After
 
PDHs
Classes
After
 
PennDOT:
1.50
11/16/10
 

Awarding continuing education credits (PDH/CEU/CEH) to a training course or other training event does not imply or guarantee that the training course/event is approved by the Pennsylvania State Registration Board of Professional Engineers, Geologists and Land Surveyors.

According to Pennsylvania Act 25, “Credit determination for activities…shall be the responsibility of the licensee.  Continuing professional competency obtained by a licensee should maintain, improve or expand skills or knowledge obtained prior to initial licensure, including law and ethics applicable to the profession, or develop new and relevant skills and knowledge.”

For informational purposes only:1 CEU is equal to 10 hours of instruction
1 CEH is equal to 1 hour of instruction


Contact Information


Name:
Jonie L Buggy
Phone:
(717) 409-3993
Email:
jbuggyz@pa.gov



Created
Last Modified
By Judy Bortz/PennDOT
On 04/19/11 At 11:03 AM
By Daniel E Sanchez/PennDOT
On 12/15/16 At 08:47 AM